Not Going to Sub Zone when Setting Up

Step 1 – This could be a case where bumper calibration is needed.

  1. Take the mower out of the base station and perform Bumper Calibration through Service ⇢ 897 ⇢ Calibrations ⇢ Bumper.
  2. Place the mower in the base station and send it to mow.

Did it solve the issue?

If Yes – Problem fixed.

If No – Proceed to Step 2.

Step 2 – In this case we need to diagnose the mower perimeter wire related hardware. See the article No Wire Signal Message.